Today We Make Our Very Own Electronic Boost Control Solenoid! Join our Community of DIY’ers: http://www.youtube.com/user/everythingdiy?sub_confirmation=1 Follow us on Facebook for More DIY Goodness: https://ift.tt/1NbEK05
Follow us on Twitter! https://twitter.com/everything_diy
Check out our pictures on Instagram! https://ift.tt/1tYrpxv
This task is very simple- all you really need is: the correct wiring harness, the right wattage solenoid, and a few barb pipes. After that, it’s simple splicing and soldering. This is pretty much the same product you are buying from other manufacturers like Cobb or Grimmspeed, but at a third of the price. This valve will work just as well due to the fact that it uses the same MAC EBCS that most manufacturers use.
Tools Used:
– Soldering Tools (Solder, Iron and Flux)
– Wire Stripper
– Plumbers Tape
– Heat Gun
Products Used
– MAC 5.4 Watt EBCS
– Mazda Wiring Harness
– 1/8 inch 90 Degree Barb Pipes
– Heat Shrink Wire Wrap
The techniques shown in this video apply to various turbo vehicles that include, but are not limited to the following:
Mazdaspeed3
Mazdaspeed6
WRX
WRX STI
EVO
GENSIS
Specific Part Numbers for Products Used in this Video:
-MAC 5.4 Watt EBCS (Part # 35A-AAA-DDBA-1BA)
-90 Degree Metal Barb (Part # ELB60-1/8)
-Mazda Wiring Harness (Part # CONN-85730)
The DIY rep in this video is Ally!
To send letters, products for review/use, other correspondence – please use this address:
everythingdiy
P.O. Box 186
Pasadena, CA 91102
FTC Disclaimer:
All products mentioned were purchased by us. None of the companies mentioned are paying us for this video. All opinions are our own.
Other Disclaimers- Everything you do is at your own risk. Everything DIY or its affiliates are not responsible for any personal injury or property damages incurred.
***SAFETY FIRST EVERY TIME***
source
The post DIY ELECTRONIC BOOST CONTROL SOLENOID! appeared first on Techie In.